Novices that are entering into painting a car for the first time, do not realize that there are various primers and paint systems available. There’re selections that have to be made as to which ones to go with. It must likewise be realised that numerous of these systems can be chemically volatile, and must be used with extreme caution. That doesnt mean you should be dubious about using them, it signifies that you got to know what you are doing and apply the correct precautions.

There are the air dry type cellulose systems for repair, then there are 2 pack products. These’re much more durable and professional but are the ones that demand caution.

For the primers theres the etching primer. This’s a primer base to which a form of acid is added. You can purchase some one step primers that come in aerosol form but they dont do quite the same high quality job that the commercial acid based ones do. You got to abide by the directions carefully.

Other type of primer you will hear about or even need is the wash primers. These don’t have any fillers and are applied in one wet coat over whatever of the areas displaying the bare metal. The etch primer fillers are a bit different because they have some basic filling qualities. These are applied in two – three wet coats, allowing 10 to 20 minutes between every application.

A heavier type of primer fillers or surfacers are available that contain filling products. Nearly all the sprayable products are designed for filling small surfaces and scratches not dents, holes our deep scratches.

Air dry is more often your primary cellulose kind products. They dry fast but they do not have the identical ability to fill the area. You could also run the risk of it shrinking once it dries out.

You’ll need to determine if youre contented working with the light aerosol fillers or if you want to go with the more intense 2 pack primer fillers. Bear in mind these’ve to be blended precisely according to directions, and applied as instructed. There’re health risks that you got to safeguard against too. In the long run they do provide a much supreme finish, but you need to decide does the job youre doing need this. If not then stay with the aerosol products. On the other hand, if youre not familiar at all with primers, then perhaps you could get some expert help or advise on the matter.

Be it which type you decide to go with , they all have the amount of applications that will be necessary. Then they’ll instruct you on what your following steps are after drying for example how many coats are required and how much sanding is required.

There are new products coming out on the market constantly. It’s always a great idea to check with your supplier as to what they recommend. They are commonly well versed in the products they carry and could give you a couple of really good advice.